Optički SFP BlueOptics AT-SPFX/2-BO 2000 m aluminij

The BlueOptics AT-SPFX/2-BO is a 100BASE-FX SFP fiber optic transceiver in an aluminium housing designed for optical data links up to 2000 meters over multimode fiber. The small, lightweight module (approx. 20 g) uses an LC duplex connector and supports simultaneous transmit and receive at 1310 nm. It complies with industry MSA dimensions and electrical interfaces and is compatible with systems that support the Allied Telesis AT-SPFX/2 100BASE-FX SFP form factor and protocol.

Advantages

The module provides a compact aluminium enclosure that combines mechanical robustness with low weight. It supports standard LC duplex multimode connections and is engineered for interoperability with major networking hardware that accepts the corresponding 100BASE-FX SFP. Built and tested to MSA-compatible quality standards, the transceiver is compatible with digital diagnostics monitoring (DDM/DOM) when supported by the host device, enabling remote monitoring of parameters such as supply voltage, laser bias current, optical output and input power, and temperature.

Suitable for

Key specifications

How to use

Insert the SFP module into a compatible SFP slot on the target switch, router or other networking equipment while the host device is powered according to the vendor’s instructions. Attach LC duplex patch cables to the module’s connector, observing correct transmit/receive alignment and fiber type (multimode). Configure the host port for 100BASE-FX if manual configuration is required; otherwise allow the device to detect and configure the link automatically. If the host supports DDM/DOM, monitor diagnostic values through the management interface to verify optical power levels and temperature.

Recommendations

Use OM1/OM2/OM3 multimode fiber with appropriate LC duplex patch cords and route connections through patch panels where possible. Verify that the host hardware firmware supports third-party SFP modules and DDM/DOM if you require remote diagnostics. Avoid excessive bending of fiber cables and ensure connectors are clean before insertion to maintain link quality and achieve the specified 2000 m range.